The thread: Everything happens in a thin layer — page 13
125 essays carry this thread — page 13 of 14.
What is taught wrongly
The side that turns turbulent first decides who arrives first near the wall
Inside a laminar layer the upper parcel's lead over the lower grows with depth. Real wings are not laminar to the trailing edge: one surface's layer turns turbulent first, and a turbulent layer is full almost to the wall. At the incidences a wing flies at, the upper side goes first and the exaggerated lead survives to the trailing edge, smaller than the laminar one and shrinking with the Reynolds number. Below about one degree the lower side goes first, and a tenth of the way into the layer the lower parcel arrives first.
Transition and turbulence
A layer whose stress lags the gradient separates sooner
A turbulent boundary layer that meets an adverse pressure gradient suddenly cannot answer it at once: the large eddies that carry its shear stress were made upstream, on a flat plate, and they draw in too little fluid for the new gradient for the first twenty or so layer thicknesses. The deficit does not protect the layer. It lets the gradient pile momentum deficit into it, so the layer reaches its new equilibrium shape quickly, its friction falls through the equilibrium value on the way, and in a strong gradient it separates in little more than half the distance a calculation without the lag predicts.
Viscosity
A scraper held flat is pushed off the wall it scrapes
A corner stirred from far away fills with an endless sequence of eddies. Drive the corner at the corner instead — let one of its walls slide under a still blade, as paint slides under a scraper — and the eddies vanish: every streamline turns once, and the stress rises into the corner without limit. G. I. Taylor solved it in 1962. The paint pushes the blade away from the wall with a force that grows as one over the square of the blade's angle, so a blade held flat rides up on what it was meant to remove, and the force is finite only because something too small to appear in the problem ends the corner.
Compressible flow
A blunted nose delays its cone's transition only so far, and the correlation decides how far
A blunted tip leaves a sheath of hot, slow gas along a hypersonic cone, and the boundary layer growing inside it sees a lower Reynolds number and a lower Mach number than a sharp cone's. That is why bluntness is said to push transition back. Read the layer's edge through the sheath and the push has a limit: the delay grows with the nose, peaks, and falls again once the transition point lies inside the sheath. How large the peak is depends on whether the transition correlation divides by the edge Mach number — five times the sharp distance at Mach 6 for the momentum-thickness Reynolds number alone, 1.4 for its ratio to the Mach number — and every peak sits forty to sixty-five nose radii from the tip.
Transition and turbulence
A layer released from a gradient overshoots the shape it left
A turbulent layer that meets an adverse gradient suddenly entrains only half what the gradient asks, because its large eddies were made upstream, and it separates sooner than a layer that answers at once. Release it — let the outer flow stop decelerating, as at a diffuser's exit or a wing's trailing edge — and the same lag runs the other way. The eddies made in the gradient keep entraining after it has gone. The layer arrives at the release with the worse shape and, twelve thicknesses later, has the better one, its shape factor falling past the flat plate's and its friction rising past the shape-only layer's.
Regimes and numbers
Below separation a cylinder's drag is a Stokes layer, and KC stops deciding the force
Morison's equation splits the force on a cylinder in an oscillating flow into inertia and drag, and the Keulegan–Carpenter number says which dominates — once the flow separates and leaves a wake. Below that, nothing separates, and the drag term describes the thin oscillating boundary layer on the cylinder's surface. Its coefficient then grows without limit as the motion shrinks, as one over the Keulegan–Carpenter number, and that exactly cancels the number's power to decide anything: the drag's share of the force is fixed by the frequency parameter alone, a few per cent at most, until Honji's instability ends the regime.
Transition and turbulence
A camera zoomed into the cascade needs frames faster than its window remembers
A wide camera window averages away the small eddies, so its mean remembers what the large eddies remember, and a run of frames is worth as many independent values as that memory allows. Zoom the window into the inertial range and the opposite is not what happens. A small window keeps nearly all the variance and almost exactly a single probe's memory — every eddy larger than itself still fills it — but much of what it keeps is the cascade's eddies, which forget far faster than the largest ones. Its frames then stop buying at an interval a third shorter than its own memory says, and a velocity gradient in the same window needs frames thirty times faster.
What is taught wrongly
Followed rather than held, the parcels near a wing nearly tie
Parcels held at a fixed fraction of a boundary layer's thickness made the side that turns turbulent first decide which arrives first near the wall, and at a wing's ordinary incidence they gave the upper parcel a lead ten times the one outside the layer. Real smoke is not held at a depth: it follows a streamline. Near the attachment point the layer is thinner than any filament's height, so every filament starts outside it and is swallowed later, and on the upper surface, whose turbulent layer grows faster, it is swallowed deeper. Followed this way, the deep parcels at 4° arrive nearly together, and at a Reynolds number of a million the lower one can come first.
Fluids at work
The layer every airway restarts bends Murray's cube towards the turbulent pipe's
A laminar fork does not lose energy the way a turbulent one does, in a burst of mixing at the split. It loses it all the way down each daughter, because the boundary layer starts again at every flow divider and an airway a few diameters long ends before the layer has grown across it. Pedley measured that extra dissipation in 1970, and in the form he wrote it the radius cancels: it depends on the flow and the length alone. Price it into the cheapest tree and Murray's cube law gives way to a flow growing as the radius to the power twelve-fifths or thirteen-fifths, the band the turbulent pipe's exponent sits in, across the first eleven generations of a resting lung.