Fluid Flow & Aerodynamics
why things fly, and why the usual explanation is wrong
Theme

The thread: The exact theory is wrong — page 4

Page 4 of 22, continuing through the 193 essays this motif runs through.

193 essays carry this thread — page 4 of 22.

u⁺ = (1/κ) ln y⁺ + B, integrated rather than asserted. The velocity profile in wall units, produced by integrating the mixing-length closure outward from the wall. The straight portion is the log law and the constants beside it were least-squares fitted to the integrated curve over 50 < y⁺ < 500 — so the 1/κ is a measurement on the drawing rather than the number that was fed in. The viscous sublayer u⁺ = y⁺ comes out rather than being pasted on. Transition and turbulence

A guess with a constant in it

Prandtl's mixing length is one line — an eddy near a wall can only be as big as its distance from the wall. Integrate it and the whole structure of a turbulent wall profile falls out, sublayer and log region and all. That is a fact about the assumption, and the essay is careful about which.

 Flow net — a free vortex. Two families of curves drawn over the same flow: the streamlines, along which the streamfunction is constant, and the equipotentials, along which the velocity potential is constant. They cross at right angles at every point, because they are the two parts of a single analytic function of position. Ideal flow

A wall made by reflection

Imposing a boundary condition on a plane is work. Putting a mirrored copy of everything on the far side of where the plane would be is not, and the plane then appears on its own — as a consequence of the symmetry rather than as a condition anybody enforced.

 A normal shock at Mach 2.00, and what crosses it unchanged. The state in front of the shock and the state behind it. Every ratio was computed from the standard jump relations and then substituted back into mass, momentum and energy, which is an independent route — a mistyped exponent in the total-pressure expression cannot survive a momentum balance it never appeared in. The residuals are printed below because a check nobody can see is a check nobody can audit. Compressible flow

The jump the equations allow

A shock is a discontinuity in a fluid, which sounds like a breakdown of the description rather than a solution of it. It is a solution: mass, momentum and energy can all be satisfied across a jump, and every ratio across one follows from that alone.

 Where the flow over the section first reaches Mach one. Two curves running towards each other. The falling one is the section's peak suction, solved exactly in incompressible flow and then deepened by the Prandtl–Glauert factor as the free-stream Mach number rises. The rising one is the pressure coefficient at which the local flow would be exactly sonic. Where they cross is the critical Mach number, and above it there is a pocket of supersonic flow on a subsonic aeroplane. Regimes and numbers

The pocket on top of the wing

An airliner cruising at Mach 0.85 has subsonic flow almost everywhere and a patch of supersonic flow over its wing. Closing that patch takes a shock, the shock separates the layer beneath it, and the correction that predicts all of this also predicts, in the plainest terms, where it stops being true.

 Circulation across the span, for three planforms. How much circulation each part of the wing carries, plotted across the span. It has to reach zero at both tips, because a wing cannot carry circulation off its end, and the rate at which it falls is what determines the vorticity shed into the wake. Circulation and lift

The price of having ends

An infinitely long wing in a fluid with no viscosity has no drag at all. Cut two ends into it and the drag appears — not from friction, which is still absent, but from the fact that circulation cannot be carried off the end of anything.

 Pressure recovery along the upper surface at 6°. Surface speed and the local Falkner–Skan pressure-gradient parameter, plotted along the upper surface from the nose. The speed peaks near the leading edge and then falls, which is the layer climbing back up to the pressure it started at, and the parameter crosses the separation value where that climb becomes too steep. Viscosity

Where the straight line stops

Ideal flow will report a lift coefficient at forty degrees of incidence without complaint. What ends the lift curve is the boundary layer refusing to follow the surface, and the estimate of when that happens joins two solvers that have nothing else in common.

 The circle plane and the aerofoil plane. A circle with a polar net around it, and the same net after the Joukowski map. Curves that crossed at right angles still cross at right angles everywhere except at the single point where the map's derivative vanishes, and that point is the sharp trailing edge. Ideal flow

From a circle to a wing

The flow past a circular cylinder is known exactly and is of no interest to anybody who wants to fly. A change of variable turns that circle into a wing section — and, because the change of variable preserves angles, it carries the whole solution across with it. Nothing is solved twice.

 Where the flow stops, at Γ = -9. A cylinder with circulation, with the points where the flow is at rest marked. As the circulation grows the two points slide round the surface towards each other, meet at the bottom, and then leave the body — after which there is nowhere on the surface where the air is at rest at all. Circulation and lift

How much circulation is too much

Spin a cylinder faster and it lifts harder, with no limit in the equations. What does have a limit is the flow's willingness to stop anywhere on the surface — the two points where the air is at rest slide round towards each other, meet at the bottom, and leave the body altogether.

 The speed for least drag is not the speed for least power. Drag and power against airspeed, in units of the speed at which drag is least. Power is drag times speed, so its minimum sits slower — at the fourth root of a third of the least-drag speed, which is 0.76 of it. Flying for range and flying for endurance are therefore different speeds, and the difference is not a rule of thumb. Viscosity

The cheapest way to stay up

There is a speed at which an aircraft's drag is least, and a different, slower speed at which its power is least. The ratio between them is the fourth root of a third — a number that does not depend on the aircraft, the altitude, or anything else about the flight.

All themes