Fluid Flow & Aerodynamics
why things fly, and why the usual explanation is wrong
Concept

Absolute pressure — where it appears

Pressure measured from vacuum rather than from the ambient, which is the scale on which it can never be negative. Working in it settles the arguments about suction: a fluid is pushed rather than pulled, and the least available pressure is zero.

Named by 10 essays across 2 fields — each of them below, with the objects they name alongside it.

What a barometer on the wing would read at 60 m/s. The absolute pressure along an aerofoil's surface, in kilopascals, with the atmosphere put back. Nothing on the wing is near zero: the deepest point of the so-called suction peak is a few per cent below a hundred kilopascals, and the air there is still pushing on the wing hard enough to hold up a column of itself eight kilometres tall. The lift is the difference between two large pushes, not a pull.

Nothing sucks

The upper surface of a wing is universally described as being under suction, which sounds like a pull. A fluid cannot pull. The lowest absolute pressure on a wing at sixty metres a second is 96 kilopascals — a five per cent dip in a hundred — and the force does not depend on where zero was put, because the normals of a closed body sum to nothing.

misconceptions · Suction Two heights, and only one of them is in the answer. A siphon, with the two heights that get confused. The drop from the source surface to the outlet is what drives the flow: the exit speed is √(2gΔz) = 4.43 m/s and nothing else enters it. The rise to the crown decides the pressure at the top — 72.0 kPa absolute here, against an atmosphere of 101.3 — and therefore whether the column holds together at all. A siphon over a high wall and one over a kerb, draining to the same place, flow at exactly the same rate.

The siphon that does not need the air

A siphon is explained everywhere by the atmosphere pushing the liquid over the hump. The flow rate says otherwise, in the flattest way available — the height of the hump does not appear in it at all. What the atmosphere does is hold the column together, which is a different job with a different limit.

misconceptions · Siphon The one calculation in which the atmosphere really does push. How high a partial vacuum inside the tube will raise the liquid, against the absolute pressure achieved inside it. The lift is (p_atm − p_inside)/ρg and it is capped at the barometric height of 10.11 m, because below the vapour pressure the liquid boils and pulling harder buys nothing. The horizontal lines are five crown heights: a crown below a line's intersection with the curve can be primed by suction and one above it cannot, at any pump. This is the process the running siphon's argument explicitly excluded, and it is the one where the atmospheric account is the mechanism rather than a limit.

The one place the atmosphere pushes

The height of a siphon's hump is not in its flow rate, and the atmosphere holds the column together rather than driving it. That account excludes one process by name — starting. That is the process the atmospheric account describes correctly, and it is the only one in the whole device.

misconceptions · Siphon The source falls 6 m and the crown pressure does not move. The pressure at the crown of a draining siphon, against time, as the source level falls from the top of the tank to the end of the run, a drop of 6 m. It is flat to 1.5e-11 pascals — not nearly flat, exactly flat, because the two effects of a falling source cancel identically. Losing a metre of level shrinks the drop, which slows the flow and raises the crown pressure by half a velocity head; and it grows the rise, which lowers the crown pressure by ρg per metre. Those are the same number. So a siphon that starts will not break as it drains, however far the level falls, and the run ended because the level reached the outlet instead.

The siphon that does not break

A draining reservoir shrinks the drop and grows the rise at the same time, and the siphon's own coupling — a metre of extra drop costs a metre of hump — says a siphon should break as it empties. It does not. The two effects cancel exactly, and the crown pressure of a draining siphon is a constant that does not contain the source level at all.

misconceptions · Siphon Identical lift at every altitude, and the skin load nearly doubles. The same wing at the same dynamic pressure at seven altitudes. The lift is identical at every one of them — the flat line, computed from the absolute pressures rather than assumed, because a net force cannot depend on where the pressure datum is set. The load on a vented panel is identical too, at 4.86 kPa, because both sides of it moved together. The load on a sealed panel with 75.26 kPa inside is not: it is 28.27 kPa at sea level and 60.84 kPa at twelve kilometres. The datum cancelled in the force and it is one of the two numbers in the stress.

A force forgets the datum, a stress cannot

Nothing sucks, because the pressure datum cancels — the normals of a closed body sum to nothing, so the lift is the same in gauge or absolute pressure. That identity is about a resultant, and it is routinely carried one step too far. The load on a panel of skin has the ambient in it as one of two numbers, not as a datum.

misconceptions · Suction 100 metres of water, −1.98 MPa absolute at the top. The absolute pressure up a transpiring column 100 metres tall, with the sap rising at 0.25 mm/s through conduits 40 µm across. It starts at 1.3 kPa at the root, falls by 9.79 kPa a metre for gravity and 10.02 for friction, and reaches −1.98 MPa at the top — below zero, which is not a low push but a pull. The pale line is the same column with nothing flowing. The floor is not the vapour pressure but the pore a gas bubble could be drawn through: −2.81 MPa for a 50 nm pore, which this column would reach at 142 metres. A suction pump lifting the same water from a free surface stops at 10.1 metres, because it offers the water somewhere to boil.

Where a liquid does pull

A fluid cannot pull, and the essays that settle what suction is are right about every gas and every liquid with a free surface near it. A liquid with nothing in it to boil on is another matter. Every tree taller than ten metres depends on the difference, and the floor under it is set by the size of a pore rather than by the vapour pressure.

misconceptions · Suction A tube 10 cm across, spun: the lowest pressure is on the axis. The absolute pressure along a water-filled tube spun about its middle, open to the air at both ends, 5 cm from the axis. In the spinning frame the water is at rest under a centrifugal pull, so the pressure falls from atmospheric at each meniscus to its lowest on the axis, as a parabola. 10 thousand rpm puts −1.3 MPa there, 20 thousand rpm puts −5.4 MPa there, 30 thousand rpm puts −12.2 MPa there and 45 thousand rpm puts −27.6 MPa there. The place the water is stretched hardest is the place furthest from both free surfaces, which is the whole merit of the method: a gas cannot reach the liquid where it is weakest.

A breaking strength that is the size of a flaw

Water can be stretched, and how far is a measurement people have made for a century and a half with instruments that agree with one another and not with the theory. Spinning a tube puts the stretch where no gas can reach it, sealing one caps the stretch at water's density maximum, and every measured number turns out to name the size of the worst cavity in the sample.

misconceptions · Suction The shaft speed is a window, and cavitation closes the top of it. Two groups against shaft speed for the same duty: the specific speed, which must be inside a band for a runner to exist, and the suction specific speed, which must be below about 3 for the impeller not to cavitate. Both rise with the shaft speed, so raising it to reach a band is also raising it towards the cavitation limit. The window here runs from 274.98 rpm to 962.31 rpm and cavitation sets its top. A duty whose window is empty needs something other than a different machine — a booster, a lower installation, or an inducer.

The group with no head in it

The number that picks a machine says nothing about whether the machine can exist. A second group formed from the same variables, with the delivered head replaced by the margin available at the inlet, decides that — and the delivered head has left the expression entirely, so how far a pump lifts is irrelevant to whether it tears the liquid apart at its own entrance.

applied · Specific speed Friction lends the crown 28.4 kPa, and the tank takes it back. The absolute pressure at the crown of a siphon with friction in its hose, through a whole drain, for the crown placed at three positions along the hose, against the frictionless constant of 23.01 kPa. With the crown 0.3 of the way it starts at 63.3 kPa, with the crown 0.5 along it starts at 51.5 kPa and with the crown 0.7 of the way it starts at 40.4 kPa. Every curve is above the constant, every curve falls towards it as the level falls, and every curve reaches it at the end — 23.06 kPa with a centimetre of level left. Friction never brings a siphon nearer to breaking; it lends a margin, and the draining tank returns it pascal by pascal, so the worst the crown ever sees is the frictionless value.

The margin friction lends a siphon

Without friction a draining siphon's crown pressure does not depend on the source level at all, and every real hose has friction. It turns out always to raise the crown pressure, by an amount the draining tank hands back pascal by pascal — and how much it lends is decided by where along the hose the crown sits, not by how rough or how narrow the hose is.

misconceptions · Siphon A litre of water at the crown carries 77 mL of gas it cannot hold. The volume of free gas a litre of air-saturated water can release at a siphon's crown, at the crown's own pressure, against that pressure, on a logarithmic scale, at three temperatures. It is zero at atmospheric and grows without limit towards the vapour pressure. At the reference siphon's starting crown pressure of 51.5 kPa it is 20.6 mL, a supersaturation of 2.02; at the frictionless floor of 23.0 kPa it is 76.7 mL, a supersaturation of 4.79. Cold water carries more: 87.4 mL at 5 °C. This is the equilibrium bound — what would come out if the water stayed long enough, which it does not.

The air that breaks a siphon nothing else can

A running siphon's heights cannot break it, and its friction only postpones the moment it is most exposed. What does break a siphon that has run for a day is the air dissolved in its water, which the crown's low pressure leaves the water carrying far more of than it can hold — and which gathers only once the flow is too slow to carry a bubble away.

misconceptions · Siphon

Named alongside it

The objects these essays reach for when they reach for this one.

MisconceptionModel limitVapour pressureCavitationBarometric heightSiphonLiquid tensionSuctionEnergy equationHydrostaticsSurface tensionClosed body

All concepts